What are the requirements for the surrounding site environment when the dry mortar equipment manufacturers install the equipment?
讲述当设备开机前我们要注意的是，先要打开各个设备的观察口、出料口、进料口等进行观察，是否还有残留物和杂物。 As long as dry-mixed mortar is the next partner in the building mortar industry, it must be familiar. Dry-mixed mortar equipment manufacturers tell us that when the device is turned on, we must first open the observation ports and outlets of each device. Observe whether there are residues and sundries at the feed port and feed port.
If you want to clean it, you can wait for it to be turned on before you start the work. During the work process, it is strictly forbidden to put hands and hard objects and sundries in the equipment. To extend the life of the equipment's motor, then work The equipment power supply should be grounded.
在生产工作过程中为了要确保使用人员的生命安全，那么各个设备的控制开关都得对其进行防漏电处理。 After turning on the equipment, it is necessary to perform an idling heat engine for 5-10 minutes. No abnormalities can be found in the heat engine before it can be used for production. In the production process of dry-mix mortar equipment manufacturers, in order to ensure the safety of users, the control of each equipment The switches must be protected against leakage.
It is strictly forbidden for non-professional personnel to inspect, repair and debug the equipment. After the equipment is put into use, it is necessary to strictly perform regular maintenance on the equipment to improve the equipment's working efficiency and increase the equipment's service life.
设备安装，要选择便于通风且干燥的地方，还要对周围环保持清洁卫生，定期检查传动皮带的松紧程度及连接部位的螺丝，并做适当调整，整套设备属于间隙式混合搅拌设备，注意单次的工作量不能超过设备的规定量，严格遵守空机启动。 Dry-mixed mortar equipment manufacturers install equipment, choose a place that is easy to ventilate and dry, and keep the surrounding ring clean and sanitary. Regularly check the tightness of the transmission belt and the screws at the connection parts, and make appropriate adjustments. The whole set of equipment is a gap-type mixing Mixing equipment, pay attention to the single workload can not exceed the specified amount of equipment, strictly observe the empty machine start.