How to clean the components of dry-mix mortar production equipment
In recent years, the application scope of dry-mixed mortar production equipment has gradually increased after being vigorously promoted by various regional governments. With the increasing demand for dry mortar at various construction sites, the equipment needs to work in harsh environments for a long time to meet the needs of mortar for each project. However, many dry mortar equipment operators did not clean up the residual mortar in the equipment at the end of the equipment work, which caused the equipment or personnel to be injured due to the load starting at the next startup. Therefore, after the work of the dry powder mortar equipment is completed, the equipment must be cleaned in time. So what harm can be caused if the equipment is not cleaned in time? We all know that the cleaning of large-scale machinery and equipment is a problem. Let's find out.
When using parts, please pay attention to the following points when cleaning parts:
1. The hydraulic components should be cleaned and sealed with plastic plugs when leaving the factory. If the storage time is not more than two years, there is no need to clean the inside of the components.
2. The hydraulic hose can be spray-washed with high-speed liquid flow, and the hard pipe can also be cleaned with the same method.
3. For the parts of high-precision hydraulic components, ultrasonic methods can be used for cleaning.
4. The components in dry mortar equipment are usually cleaned with kerosene. Please note that gasoline is prohibited.
The above is how to clean the parts of the equipment described by the dry-mix mortar production equipment manufacturers. I hope to give you some help. If you want to know more, you can contact us or leave a message.