Reasons for slow feeding speed of screw conveyor for dry-mixed mortar production equipment
The reason for the slow feeding speed of the screw conveyor of dry-mix mortar production equipment is that the screw conveyor is the main part of the feeding, which directly affects the production efficiency of the entire production line. Once the screw conveyor has a slow feeding situation, how can we solve the feeding problem? Slow question then?
According to many years of equipment production experience, the main reasons for the full load of the spiral elevator are as follows:
1. The elevator bearings feed powder, and the bearings below the elevator are easy to feed powder, which causes the bearing friction to increase and the lifting efficiency to be poor;
2. The blades of the elevator are worn. If the raw materials are lifted for a long time, the blades of the elevator will be worn and the feeding speed is not good.
3. The lifter blade enters the foreign body. Improper feeding of the lifter can easily cause foreign matter such as woven bags to enter, thereby affecting the feeding efficiency;
4, the belt is slack, the motor belt is a wearing part, after a long time of use, the belt wears and looses and slips, which affects the feeding speed;
Tips for dry-mixed mortar production equipment: In the process of using the dry powder mixer, slow feeding and abnormal feeding are encountered. Please check according to the above methods. During normal use, regular inspection and regular lubrication are required. If the new equipment is not feeding, please check whether the direction of rotation of the motor is the same as the direction of the logo of the elevator. If the direction is not the same, adjust it. All in all, the correct installation and the habit of regular inspection and maintenance can ensure the normal operation of the equipment and extend the service life.
If the equipment encounters some problems during production, such as the slow feeding of the screw conveyor mentioned above. There are good solutions. In order to ensure good operation and production, pay attention to equipment maintenance. This should be the solution for slow feeding of the screw conveyor. The first job is the product, and the good job is the service.