Installation of dry-mixed mortar production equipment
Dry-mixed mortar production equipment manufacturers point out the steps for installing silos for thermal mortar equipment :
1: To know the height, weight, lifting height of the silo of the thermal insulation mortar equipment and determine the tonnage of the crane and the parking position of the crane.
2: Before installation, check the installation position of the silo. Ladder, air vent, and feed hole must be convenient for external maintenance. If there are more than two silos at the same time, you must determine the order of the silos. Make a mark.
3: When the height of the outrigger exceeds 4 meters, the weight of the two feet supporting weight should be taken into consideration when the bin body is placed from horizontal to hoisting, to avoid bending the supporting feet when lifting.
4: The crane places the silo on the buried iron with force, try to place the silo on the buried iron, use the hanging to correct the verticality of the silo, and support the short legs with iron plates. Guaranteed force).
5: Spot welding of each leg after calibration. After the silo body is hoisted, all the legs and ribbed plates are fully welded. If all silos cannot be hoisted on the same day, the leg welding time of the silo in place should be arranged. Fully welded silo overnight.
6: The silo feet are weighing support points. They must be fully welded and the angle of the ribs must be evenly distributed to ensure that the force in all directions is uniform.
7: For a silo with two supporting legs, you must hoist it before the feet are docked. The middle bolt connection part must be provided with a flat washer and a spring washer. Sorry for the bolt hole caused by the accumulation of errors. Welding and adding ribs Board to ensure strength.
8: Silo installation tools: tape measure, hanging, safety belt, hard hat, iron plate (for calibration), welding machine.
The above is the installation steps of the thermal insulation mortar equipment mentioned by the dry-mixed mortar production equipment manufacturer. I hope it can help everyone.